Usually, the price for irrigation opening is $100 + tax. The price can vary if the system is commercial or big residential.
GET IT NOWBasically, the price for winterization is $100 + tax. The cost can vary if the system is commercial or big residential.
GET IT NOWPrices start at $550 per zone. We use Hunter and Rain Bird materials. 5-year warranty. Parts and labor are included.
GET IT NOWLED fixtures start from $250 due to long lifespan and reduced maintenance costs. Parts & labour are included.
GET IT NOWResidential sod averages $1.10–$3.50 per sq.ft. Commercial starts at $0.75. Labour is included.
GET IT NOWFrench drainage installation cost ranges $25–$40 per foot depending on complexity. Parts and labor are included.
GET IT NOWFull inspection, diagnostics, pressure testing, and system adjustments.
BOOK ONLINE
A sprinkler zone that stays on is usually caused by a valve that is stuck open, debris in the diaphragm, or a manual bleed left open.
If one sprinkler zone stays on after the controller turns off, the answer is usually yes: the valve is stuck open mechanically. The most common causes are debris trapped under the diaphragm, a torn diaphragm, a loose bleed screw, a solenoid left in manual-open position, or a damaged valve body. A timer problem is possible, but less common. The easiest fact check is simple: turn the controller off. If the zone keeps running, shut off the irrigation water supply. If water only stops when the supply valve is closed, the zone valve is not sealing and needs cleaning, rebuilding, or replacement.
| Question | Certain Answer |
|---|---|
| Most likely cause | Debris or a damaged diaphragm preventing the valve from closing. |
| Controller or valve? | Usually valve. If it runs with the controller off, it is mechanically stuck open. |
| Risk level | High, because a stuck zone can flood lawns, wash out soil, and waste a lot of water. |
| Best next step | Close the irrigation shutoff, inspect the bleed screw and solenoid, then clean or rebuild the valve. |
Small debris can prevent the diaphragm from sealing and keep water flowing to the zone.
A bleed screw or solenoid opened for testing can keep the valve running until it is closed properly.
A torn or warped diaphragm may not seal even when the controller stops sending power.
Less commonly, the controller may continue sending voltage or wires may be crossed.
If the zone stops when you shut off the irrigation water but not when you shut off the controller, the valve is likely mechanically open. If it stops when the controller terminal is disconnected, investigate the timer or wiring.
A stuck-on zone should be repaired quickly because it can flood lawns, damage sod, waste water, and wash soil away from roots or hardscape edges.
Additional factual note: A valve can stick open after main-line repairs, spring startup, or dirty water entering the system. Small debris can hold the diaphragm open even when the solenoid is no longer energized.
Additional factual note: Do not let a stuck zone run for hours. Besides water waste, saturated soil can damage new sod, drown plant roots, and create soft spots around walkways or patios.
The valve is likely stuck open mechanically or the manual bleed is open.
Yes. Debris under the diaphragm is a common cause.
It can, but valve problems are more common.
Shut off the irrigation supply or backflow/main valve feeding the sprinkler system.
Need help with sprinkler valves, heads, timers, wiring, rain sensors, or low-pressure zones in Toronto or the GTA? A proper diagnosis can prevent wasted water, lawn damage, and repeat repairs.
Book Sprinkler Repair
